This lamp will give a very particular style to your room. Easy to produce, and with little cost.
Materials:
screws, screwdriver, socket, table pan, plastic or cardboard tube, foot switch, plug, power cord,
Procedure:
start with the preparation of the bands leaves the barrel. The doing is prepared as a braid the hair. In the same way. This
bands we will use to cover the ugly wire. I highly recommend using long leaves and robust because it will cover the entire circumference of the shaft of light.
now take the rod of wood, let's groove a few inches of the end of it, leaving a few inches from the end. In this slot we will pass the thread. At the center of the end of the piece of wood in which we had to slot drills with a point wide enough to pass the wire even at this point.
At this point we can put the lamp holder into the hole and thread the wires connecting the lamp holder to block everything.
Insert the wire and the piece of timber with the bulb inside the plastic tube and you stare at the wood with screws and so we have a complete end.
Now we can move on to the base. Let's take the other rod of wood and there form a groove on the side enough to pass the wire and then attach it to the base with a screw long enough.
Now we can attack the plastic tube (the other end) to this base by passing the wire into the groove.
We then completed the auction and the platform.
now use the foot switch to the wire and the last of the male plug. Now comes the most
nice, that is, wrap the pipe with the tie rods and wire, then we cover the wire with the loop created by the leaves and behold, our lamp is ready.
Just from lampshade, adding a floor lamp and a light bulb.
Good job. I apologize for the poor picture quality but my skills are very limited in design, but I think it is more simple for everyone to see what is being described.
In the coming days, however, will change the images by entering a much more complete and better data to be released from the hands of my partner instead of mine.
0 comments:
Post a Comment